Stone Quarry Haverstraw New York, Rockland County NY

Haverstraw Quarry 66 Scratchup Road Haverstraw, NY 10927
PRODUCTS		Stone, Asphalt

PHONE
	Pricing:	845-480-3249 or 845-480-3190
	Orders:	800-872-7762

HOURS*		Stone: Monday to Friday 5:00am to 3:30pm. Asphalt: The Asphalt will Open for the Season: Monday Apil 14th Monday to Friday 7:00am to 3:30pm.
*	Facility may open outside of these hours based on customer demand. Please call our NY Order Department or your Sales Representative for details.

DIRECTIONS To Shop/Office: Take the NYS Thruway to Exit 12 (stay to the left). At the second light make a left onto Route 303 North. Stay on Rt. 303 North. Rt. 303 turns into 9W. Take 9W approximately 1/4 mile. Look for the Tilcon Haverstraw Quarry sign on the left this will be Long Clove Road. Make a left onto Long Clove Road follow the road past the training center approximately 1/4 mile to the plant To Plant: Take the NYS Thruway to Exit 12(stay to the left). At the second light make a left onto Route 303 North. Stay on Rt. 303 North. Rt 303 turns into 9W. Follow 9W to plant entrance on right.

PRODUCTS:
Rock Type: Trap Rock Specific Gravity: Bulk (SSD) 2.86, range 2.826 – 2.912 * Source No: 8-10R * Specific gravities and unit weights are subject to change and should be verified before use
STONE	Application
3 1/2" minus	Used in erosion control
1 1/2 ”	Used in tracking pads and erosion control and railroad ballast
1 1/4"	Used in railroad ballast
3/4"	Used in hot mix asphalt, Portland cement concrete and as a drainage material
ASTM 57	Used in concrete and drainage
1/2"	Used in hot mix asphalt and concrete
3/8”	Used in hot mix asphalt and Portland cement concrete
1/4"	Used in hot mix asphalt and block mix
Manufactured Sand	Used in hot mix asphalt, Portland cement concrete, septic system bedding material
Screenings	Used in hot mix asphalt, in many types of aggregate blends for specialty products
Item 4	Used as a sub base under roadways, compactable fill material
Railroad ballast also available. **Not always readily available, please speak to your Sales Rep or Inside Sales for availability.
ASPHALT	Application
Marshall Mixes:
Type 1 Base	A dense graded base or binder course
Type 2 Base (Open)	General road bas
Type 3 Dense Binder	A dense graded base or binder course
Type 5 Shim	A sand and asphalt mix used for crack filling and low areas in roadways and parking lots
Type 6 Top (Regular Fine)	A surface course for medium to heavy traffic roadways
Type 6F	A surface course mix for low to medium traffic roadways
Type 7 Top (Extra Fine)	A fine surface course
Curb Mix	A fine mix used for curbs
Superpave:
37.5mm	A course graded base course used for all traffic levels with different ESAL levels
25mm	A course graded binder course used for all traffic levels
19mm	A dense graded binder course used for all traffic levels
12.5mm	A surface course used for all traffic levels with different ESAL levels
9.5mm	A fine surface course
Shim	Used to repair small areas in roadways and parking lots
Please note: All NY asphalt plants supply NY State DOT approved mixes.